Author |
Topic |
|
nigel stroud
United Kingdom
110 Posts |
Posted - 23/12/2015 : 17:45:10
|
Need an excuse to hide in your shed for a few hours over Christmas?! Perhaps you could have a rummage for the following parts!
Scuttle fuel tank Late type rear wings Dash panel Windscreen mounting pillars Late type headlight supports Front valance Side valances Exhaust down pipe Rear springs Hartford dampers x2 Sump Dynamo (late) 6v and bevel gear Crank bevel gear and spacers Starter dog nut Oil pump and gear oil pump spiral gear Oil drain pipes f&r
Any help with the above would be greatly appreciated and help resurrect another MMM car back on the road! |
|
bob
United Kingdom
335 Posts |
Posted - 23/12/2015 : 19:01:20
|
Nigel I can help you e-mail sent Bob |
|
|
Richard Hardy
United Kingdom
2165 Posts |
Posted - 23/12/2015 : 20:56:42
|
Nigel
I suspect I have several oil pumps with drive gears attached if this helps
Cheers
Rich
Vintage MG Parts |
|
|
Malcolm Eades
United Kingdom
379 Posts |
Posted - 24/12/2015 : 11:59:46
|
Nigel,
I have a pair of re-manufactured windscreen support pillars (plain castings needing drilling and chroming). They are the taller version but they are based on the earlier type with a sort of nib that fits under the corner of the screen frame. If your car is a later one, I think a plain twisted bar is more correct. Let me know if you're interested.
If anyone else needs these, I have plastic 3D-printed replicas that my foundry uses to make the sand moulds, so I can easliy get more made.
Malcolm M Type
|
|
|
tonym
United Kingdom
653 Posts |
Posted - 24/12/2015 : 15:04:51
|
Nigel I have a tank that has a small crack in it - otherwise it is sound. If it is of any use to you. Can send you a pic, if needed. Ian Judd, on this forum, has produced new downpipes in the past - contact him to see if he can help. Tony |
|
|
nigel stroud
United Kingdom
110 Posts |
Posted - 24/12/2015 : 16:17:56
|
Thanks for your replies which I hope I have answered off line. So far I think I might have an oil pump and drive gears, a front drain tube,a fuel tank and a source for windscreen support castings. Nigel |
|
|
Malcolm Eades
United Kingdom
379 Posts |
Posted - 29/01/2016 : 13:14:42
|
Nigel,
I did receive your original message and have received the follow up today. However my original reply does not seem to have reached you. I have copied it to you this morning, so check your inbox. There may be a problem. (Going to spam or junk?)
Malcolm M Type
|
|
|
ja.mcnab
United Kingdom
204 Posts |
Posted - 29/01/2016 : 17:10:26
|
I think I have some road springs - in Lincs - but I live in Herts - so will have to wait until I next go there. A few other bits - prop shaft, front engine housing, clutch plates etc. |
|
|
|
Topic |
|