Author |
Topic ![Next Topic Next Topic](images/icon_go_right.gif) |
|
PimL1
Netherlands
120 Posts |
Posted - 08/11/2020 : 14:40:13
|
Hello there,
Looking for a die 7/32 BSF 28 tpi. If not, 6 Studs with that size are welcome. Total length about 20 cm. Try to repair a Lucas Altette horn. I still have the 6 chromed domed nuts. Suggestions? Thanks for all your info. Pim L1/0491 |
|
paul55
Luxembourg
732 Posts |
|
mjb
United Kingdom
249 Posts |
Posted - 08/11/2020 : 15:16:03
|
Hello Pim, Try Tracey Tools Ltd here in the uk, they should be able to supply the dye size you need, contact details are as follows: tel 01803 328603 ; fax 01803 328157; www.tracytools.com info@tracytools.com; Unit 1,Parkfield Ind estate, Barton Hill Way, Torquay, Devon TQ2 8JG. Kind Regards, Mike.
mike bradbury |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Drolshagen
Germany
679 Posts |
Posted - 08/11/2020 : 15:17:23
|
Hi Pim, I donīt think there is any BSF Type thread an a Altette horn, LUCAS used BA threads on eletrical components. What you are looking for is a BA 1. here you can check all types of threads,
http://pages.cs.wisc.edu/~bolo/workshop/thread.html
cheers Carl J2 4362 L2 2036 |
Edited by - Drolshagen on 08/11/2020 15:17:38 |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Keith Durston
United Kingdom
713 Posts |
|
John Reid
United Kingdom
705 Posts |
|
Roger Cadogan
United Kingdom
493 Posts |
Posted - 08/11/2020 : 21:08:32
|
B.A. certainly.
Roger |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
PimL1
Netherlands
120 Posts |
Posted - 09/11/2020 : 16:34:55
|
Hello Gentlemen,
Thanks for all your info and tips. I will go for the BA thread. Best regards Pim |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Keith Nelson
United Kingdom
83 Posts |
Posted - 09/11/2020 : 17:06:35
|
Hi Pim Before you settle on the BA thread you might want to check the "Taff the Horns" website.There is a hand drawn sketch (quite hard to read) that gives the threads used for the various models. The BA threads suggested would seem to be for the newer horns but for for the MMM horns it suggests 1/4"BSF/BSCY (Cycle thread - 26 tpi but 60 deg thread angle). Hope this helps. Regards Keith
ON |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
|
Topic ![Next Topic Next Topic](images/icon_go_right.gif) |
|