Author |
Topic |
|
Hap Hazard
United Kingdom
123 Posts |
Posted - 12/01/2023 : 17:48:18
|
Hi folks, Has anyone out there got a PA/PB crankshaft that they are interested in selling? Regards, Bruce
You’re a long time dead…
|
|
GWeber
USA
32 Posts |
Posted - 12/01/2023 : 18:53:32
|
Hello Bruce,
I have a PA crank left over from my rebuild. It has been machined to approximately .052 inches undersize and passed magnaflux. Work was performed my Moldex in Detroit Michigan, whose clients included Indy race cars and Ferraris. Asking 1,200 pounds plus insured shipping at cost. I am located in Cleveland, Ohio, USA.
Gerry Weber |
|
|
Hap Hazard
United Kingdom
123 Posts |
Posted - 12/01/2023 : 22:56:55
|
Will see if anything comes up this side of the pond Gerry for obvious reasons, especially customs. If nothing comes up I may contact you as I may be able to arrange it to be sent to an address in Cincinatti but it will trucky to arrange. Regards, Bruce
You’re a long time dead…
|
|
|
Hillebrand
Germany
133 Posts |
Posted - 13/01/2023 : 09:06:53
|
Hello Bruce,
From rebuilding the engine of my PA900 with compressor and Phoenix crankshaft the original crank and pistons/conrods are left. I could bring the parts to Stoneleigh at 12.2. and would ask for a pocket money, because they need a refurb.
Please give me a hint via my private e-mail address.
otto |
|
|
Hap Hazard
United Kingdom
123 Posts |
Posted - 13/01/2023 : 09:17:17
|
Danke Otto, I am in Germany often with work, will PM you. GruBe, Bruce
You’re a long time dead…
|
|
|
Hap Hazard
United Kingdom
123 Posts |
Posted - 16/01/2023 : 14:34:43
|
PM sent Otto, Ready for you to pick up when you can.... Cheers, Bruce
You’re a long time dead…
|
|
|
|
Topic |
|