Triple-M Register Forums
Triple-M Register Forums
Home | Cars for Sale | My Files | Policies | Profile | Register for the forum | Active Topics | Subscribers | Search | Locate Subscribers | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Triple-M Register Forums
 Parts Wanted
 Correct brass screw/dampeners for SU Carbs on J2		  Forum Locked  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

thompson

United Kingdom
114 Posts
Posted - 12/12/2016 :  16:56:57  Show Profile
A bit like these brass tops on these carbs...

Thanks Tom

LewPalmer

USA
3256 Posts
Posted - 12/12/2016 :  17:12:29  Show Profile
The caps are readily available from Burlen Fuel Services.

Lew Palmer
PA1169, PB0560
Go to Top of Page

thompson

United Kingdom
114 Posts
Posted - 12/12/2016 :  17:17:29  Show Profile
Thanks Lew...I will give them a go...Tom
Go to Top of Page

Foz

United Kingdom
773 Posts
Posted - 12/12/2016 :  18:28:00  Show Profile
Hi Tom,
good to see you did buy the J2.
Brass SU tops are tope only..... no dampers in these orig. SUs.
FOZ
Go to Top of Page

DickMorbey

United Kingdom
3683 Posts
Posted - 12/12/2016 :  19:24:26  Show Profile
Hi Tom

Which J2 is this? We at the Register would love to know! Contact us offline?
Thanks!

Dick Morbey
PA/PB 0743
Frieth, Oxon, UK
Go to Top of Page

thompson

United Kingdom
114 Posts
Posted - 12/12/2016 :  20:05:08  Show Profile
Ps...Does anyone know what the 'funnels' are on the carbs..? And can you get them...? Tom
Go to Top of Page

LewPalmer

USA
3256 Posts
Posted - 12/12/2016 :  22:51:22  Show Profile
Those are "ram pipes" for increasing the intake of air. They too are available from Burlen, but I'm not sure they have the ones that fit the 1 inch carbs.

Lew Palmer
PA1169, PB0560
Go to Top of Page

Gordon

United Kingdom
693 Posts
Posted - 13/12/2016 :  09:58:16  Show Profile
If you fit trumpets you are likely to significantly alter the conditions at the jet and may well need new needles. To get the best a trip to a good rolling road emporium might well be cost effective.

Gordon
ex owner of PB 0331, MG4473
Derby
Go to Top of Page

thompson

United Kingdom
114 Posts
Posted - 13/12/2016 :  13:47:49  Show Profile
Thanks Gordon for this advice.

To be honest it was more an aesthetic decision as it seems to finish off the look of the carburettors...!
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked  Topic Locked
 Printer Friendly
Jump To:
Triple-M Register Forums © 2003-2024 MGCC Go To Top Of Page
Snitz Forums 2000