Author |
Topic ![Next Topic Next Topic](images/icon_go_right.gif) |
|
kimber
United Kingdom
1529 Posts |
Posted - 07/06/2013 : 07:54:27
|
May I preface this posting by saying that I did not hacksaw this part off nor did the person I acquired it from!
The purpose of the posting is twofold:-
1. I am trying with difficulty to source some suitable rivets to secure the plate with. I believe that they are aluminum 1/16" x 3/8" flat head. Have looked at quite a few of the model engineering suppliers but no flat-heads.
2. If the sawn-off bit is of any use to anyone, it's available (sans instruction plate).
![](http://farm3.staticflickr.com/2877/8974832863_ba6890152a_c.jpg) |
Edited by - kimber on 07/06/2013 07:56:29 |
|
Orstin
United Kingdom
637 Posts |
|
kimber
United Kingdom
1529 Posts |
Posted - 07/06/2013 : 08:17:58
|
I think a slim panatella may be in order... ![](images/icon_smile_big.gif) |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Colin McLachlan
United Kingdom
991 Posts |
Posted - 07/06/2013 : 08:34:05
|
I read that and immediately could hear the opening chords of "Air on a G String"
Colin
PA 0613 MG3242 Register No. 2591 |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Nick Feakes
USA
3372 Posts |
Posted - 07/06/2013 : 08:52:07
|
Would it not be fairly simple to turn a domed head rivet into a flat head one? Nick |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Orstin
United Kingdom
637 Posts |
Posted - 07/06/2013 : 09:11:42
|
'it it wiv a big 'ammer?
![](images/icon_smile_big.gif)
So many dynamos |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
MG Maverick
United Kingdom
1045 Posts |
Posted - 07/06/2013 : 10:02:59
|
I make my own rivets by turning down screws, bolts etc.
Chris ( J2353 )
Brighton, East Sussex & Paphos, Cyprus. |
![Go to Top of Page Go to Top of Page](images/icon_go_up.gif) |
|
Drolshagen
Germany
669 Posts |
|
Peter Scully
United Kingdom
157 Posts |
|
|
Topic ![Next Topic Next Topic](images/icon_go_right.gif) |
|