etaylor
Australia
27 Posts |
Posted - 08/10/2014 : 23:34:49
|
Following a recent 1500m trip in the NA, I have developed an oil leak through the oil filter housing in the vicinity of the oil pressure gauge take-off. It is coming from the underside so is hard to see in detail because it is so close to the sump.
I had a similar problem with another housing which had pin hole defects in the original casting. It was not reparable by welding due to the very poor quality of the original material. I am assuming the same will be the case with this housing so I am looking for another unit in good condition.
Can anyone help in this regard?
Thanks, Ed Taylor (NA0303)
|
|